Home / HEAT-TECH info

Author Archives: HEAT-TECH info

No.9 Automatically Changeover of Drums

[ Problem Point ] The wasted fluid is stored in drums, it can not be automatically changeover. [ ⇒Kaizen Point ] DLC-100 of the relay signal type was installed. When the wasted acid became near fill up the drum, the ...

Read More »

No.7 Supplement of hydraulic operating fluid

[ Problem Point ] Hydraulic operating fluid sometimes overflowed from the drum. [ ⇒Kaizen Point ] DLC-100L of the warning light type was installed. When fluid became near fill up the drum, the light shone, it was overflow prevention. The ...

Read More »

No.6 Refill of waste paint

[ Problem Point ] One operator is doing refill in the waste paint by himself, so it isn’t possible to see through until it’ll be fill up the drum. [ ⇒Kaizen Point ] Started using the DLC-100B  Bell type. So ...

Read More »

No.4 Landing of shipping waste oil

[ Problem Point ] When waste oil is spilled carelessly, it’s necessary to violate “MARPOL Convention” and “Law concerning the prevention of the reaching marine disaster like seawater pollution etc.” and to pay a high penalty. [ ⇒Kaizen Point ] ...

Read More »

No.2 Temporary storage of food wasted oil

[ Problem Point ] Food wasted oil sometimes overflowed from the drum. [ ⇒Kaizen Point ] We are near the residential area, so DLC-100L of the warning light type, not the bell type was installed. If oil became near fill ...

Read More »

No.1 Transfer of drain

[ Problem Point ] One operator is doing transferring in a drain by himself, so it isn’t possible to see through until it’ll be fill up the drum. [ ⇒Kaizen Point ] Started using the DLC-100B  Bell type. So loud ...

Read More »

Drum Level Communicator DLC Series

Easy to Use! It only  put into the drum, and turn on the power! By the time of fullness, the bell and light, warning sending. For Water, Oil and so on AC200V-240V Multiple power. How to use. 1. DLC insert ...

Read More »

No.84 Study of shape memory alloy

[ Problem Point ] Temperature control was difficult because it was heating with warm water. [ ⇒Kaizen Point ]  The alloy heated by the Air Blow Heater. since it heated at an exact temperature of a unit once, reproducibility of ...

Read More »

No.83 Ignition source of biomass boiler

[ Problem Point ] Because the fuel is wet, we were in trouble without good source of ignition. [ ⇒Kaizen Point ]  Output the high temperature air blow in the Air Blow Heater, was heated and dried. Since fresh air ...

Read More »

No.81 Burr melting of the Bumper

[ Problem Point ] Although the drier for industry was used for the robot, having attached it, broke down immediately and we were troubled. [ ⇒Kaizen Point ] The burr was melted with the Air Blow Heater. Since discharge temperature ...

Read More »

No.79 Thermal Diffusion test of perfumes

[ Problem Point ] There was omitted thermal diffusion test by air. [ ⇒Kaizen Point ] The diffusion test was done,the amount control of winds in increments of 1liter unit raising temperature in increments of 1 degree unit with a ...

Read More »