[ Problem Point ]
We were in trouble because there was no space where BLOWER which transfers cooling water after the back weld pulled out is installed.
[ ⇒Kaizen Point ]
It was dried at high temperature by the Power the Air Blow Heater.
Drop water could dry beautifully completely.
Related page:
No.14 Plastic resin welding 
No.14 Shrink processing 
No.14 Heating and drying of rubber gloves 
No.14 Residual quantity shortage warning of hydraulic fluid 
No.19 Recovery of resin mold 
No.57 Drying of coated steel sheets 
No.70 Heat source of nitrogen shield soldering iron 
No.81 Burr melting of the Bumper