Halogen double-sided heater HDSH-60

INDEX

1.Features of HDSH-60
2. Outline photograph of HDSH-60
3.Temperature distribution of HDSH-60
4.Temperature rising time of HDSH-60
5.Voltage and life of HDSH-60
6.Manual control → HCVD series
7. Automatic temperature control → HHC2 series
8.Configuration of HDSH-60
9.Outline drawing of HDSH-60

1.Features of HDSH-60

1) Both sides can be heated with one heater.
A halogen lamp is built into the center of the heater, and a condensing mirror is designed to heat both sides.
Installed between the objects to be heated using the residual heat of the mold, etc., it is possible to heat both sides with one heater.
Since it can be heated with just one unit, it is lightweight and energy efficient.

2) Can be connected and used in multiple units.
Multiple heaters can be used in line according to the object to be heated.

3) The rise time of the heater is a few seconds.
The heating element uses a halogen lamp, so the rise time is very fast.

4) Suitable for heating metals.
It is ideal for heating metals because it irradiates short wavelengths suitable for heating metals.

2. Outline photograph of HDSH-60

3.Temperature distribution of HDSH-60

The photo below is a thermal image obtained when a heat-resistant brick was irradiated from a distance of 30 mm.

The thermal image is divided at the maximum temperature of the temperature of the mirror range (280mmx60mm) of the halogen double -sided heater at the maximum temperature, and the temperature distribution of heat -resistant bricks is quantified.

4.Temperature rising time of HDSH-60

【please note】
In infrared heating, the heating temperature changes depending on the infrared absorption rate of the object.
The longer the heating time, the higher the temperature.

5.Voltage and life of HDSH-60

As shown in the above figure, if user lower it by 10% from the rated voltage, design life will be lengthens to 3 times.
If user lower it by 20% from the rated voltage, design life will be lengthens to 9 times.