[ Problem Point ]

I thought that I would like to use a halogen heater for the remaining heat of the printed circuit board, but I could not control the temperature without contact.

[ ⇒Kaizen Point ]

Thermocontroller for a pyrometer was mounted on the High-performance heater controller HHC2 and controlled by the signal of the pyrometer.

Since heating control can be performed without contacting the elements on the substrate, the possibility of mistaching disappeared.

Furthermore, even if the height of the part changed, it was able to heat from the same position, so the number of steps for changeover was reduced.

Moreover, since there are manual and automatic changeover switches, conditions can be easily settled.