[ Problem Point ]
Rising of the heater is slow,it couldn’t balance with coating of shrink-proofed resin.
[ ⇒Kaizen Point ]
Dried by the Halogen Line Heater after coating fabric.
Since the maximum temperature heated up in 5sec, immediately after the start of operation could work.
The idling time vanished, the current spending 30 minutes in idling until PID steady.In addition, the amount of electric use decreases, and the exhaust of CO2 has decreased, too.
Related page:
No.1 Moisture control of paper-forming process 
No.2 Dryness of medicine of paper-forming process 
No.8 Dryness of resin pellet 
No.12 Preheat of blow molding 
No.13 Heat hardening of resin material 
No.19 Molding preheating of rubber 
No.25 Resin reinforcement sticking of the stiffening glass together 
No.45 Heat source for instrument for analysis