Home / HEAT-TECH info

Author Archives: HEAT-TECH info

5-3.Efficient method of Infrared ray drying

5-3-1.Distance from the Heater

5-3-1.Distance from the Heater The infrared rays are projected from the heater to reach the heating object is propagated through space. Because the space is not being vacuum exists air, infrared rays will be to heat the air. And, correspondingly, ...

Read More »

2-7.Halogen Point Heater Lamp lifespan

The lifespan of a halogen lamp depends on the voltage used. The rated voltage is defined as 100%, and if the voltage is lowered by 10%, the lifespan is extended by about 3 times, and if the voltage is increased ...

Read More »

5-2.Heat balance equation of Infrared ray drying

Heat balance equation of Infrared ray drying

The electrical energy (electric power) supplied from the power supply serves as electromagnetic waves, and jumps out of a heating element. The electromagnetic waves exist wavelength of various kinds, but the most effective in heating is infrared rays. The low- ...

Read More »

2-6.Halogen Point Heater cooling

Continuous use of halogen point heaters always requires cooling. This is because the heat resistance temperature of the halogen lamp seal is 300°C. If the lamp is used continuously without cooling, the temperature of the sealing part will exceed 300℃ ...

Read More »

5-1.Infrared rays wavelengths and water

5-1.Infrared rays wavelengths and water

5-1-1.Water will absorb the infrared. The difference between the absorption rate by the wavelength of infrared Although there are, as shown in the figure below, the thickness of the water film it absorb 100% infrared at any wavelength and more ...

Read More »

Deburring of ABS resin

Deburring of ABS resin

*Check Video is here This video is a Deburring of ABS resin air by the Air Blow Heater. Please check the following site for more information.

Read More »

4-5.Drying speed and angle of the hot air

4-5.Drying speed and angle of the hot air - Science of the drying

The case of hot air flows parallel to the material (co-current) In order to contact a high temperature hot air near a material entrance, a drying speed is large and decreases to urgency after that. Since material contacts a high ...

Read More »

4-3.Drying speed and temperature of the hot air

Changes of the saturation water vapor amount by hot air temperature

4-3-1.Features of the hot wind heat source Dryness with constant temperature and humidity of a hot wind is called the constant drying condition. If the temperature of a hot air is changed, the relative humidity and specific heat, density, viscosity, ...

Read More »