Home / HEAT-TECH info

Author Archives: HEAT-TECH info

2-6.Halogen Point Heater cooling

Continuous use of halogen point heaters always requires cooling. This is because the heat resistance temperature of the halogen lamp seal is 300°C. If the lamp is used continuously without cooling, the temperature of the sealing part will exceed 300℃ ...

Read More »

5-1.Infrared rays wavelengths and water

5-1.Infrared rays wavelengths and water

5-1-1.Water will absorb the infrared. The difference between the absorption rate by the wavelength of infrared Although there are, as shown in the figure below, the thickness of the water film it absorb 100% infrared at any wavelength and more ...

Read More »

Deburring of ABS resin

Deburring of ABS resin

*Check Video is here This video is a Deburring of ABS resin air by the Air Blow Heater. Please check the following site for more information.

Read More »

4-5.Drying speed and angle of the hot air

4-5.Drying speed and angle of the hot air - Science of the drying

The case of hot air flows parallel to the material (co-current) In order to contact a high temperature hot air near a material entrance, a drying speed is large and decreases to urgency after that. Since material contacts a high ...

Read More »

4-3.Drying speed and temperature of the hot air

Changes of the saturation water vapor amount by hot air temperature

4-3-1.Features of the hot wind heat source Dryness with constant temperature and humidity of a hot wind is called the constant drying condition. If the temperature of a hot air is changed, the relative humidity and specific heat, density, viscosity, ...

Read More »

4-2.Drying speed and wind speed of the hot air

Drying speed and wind speed of the hot air

Temperature and Humidity of the hot air is called the steady-state drying conditions drying constant. 4-2-1.If wind velocity of a hot wind is enlarged, a coefficient of heat transfer will also become large. Heat transfer coefficient of the dry conditions ...

Read More »

No.22 High-temperature sterilization of Supatera

High-temperature sterilization of Supatera

[ Problem Point ] The small high temperature sterilization equipment not using an open flame was required. [ ⇒Kaizen Point ] It is using a Halogen Point Heater that can be sterilized in 5 seconds after lighting. Sterilization process without ...

Read More »

2-1.Overview of the Halogen Point Heater

Halogen Point Heaters convert the electricity of halogen lamps into light, A heater that uses a Condensing mirror to concentrate the light in dots and circles and heat it at a high temperature. ◎ Since it heats directly without a ...

Read More »

4-1.The air and the nitrogen

The air and the nitrogen

Check the performance of the air and nitrogen as the medium to be used in the hot-air drying. 4-1-1.The role of air Air at room temperature, the atmospheric pressure will behave as a nearly ideal gas. Density of air ρ ...

Read More »